ASTM C1407-23 PDF

ASTM C1407-23 PDF

Standard Practice for Calculating Areas, Volume, and Linear Change of Refractory Shapes

$32.00 $64.00 -50%
Product Code: ASTM C1407
Stock In Stock
Published: 2023
Number of Pages: 2

Available Options

Product Description

Significance and Use
 3.1  Fireclay steel-teeming nozzles and sleeves are classified by volume reheat change. Bloating of some refractories results in irregular reheat dimensions, which are difficult to measure. This practice determines the volume without depending upon physical linear measurements.
 3.2  Blast furnace checkers that have irregular cross-sections are classified by “creep properties.” This practice determines the average cross-sectional area.
 Scope
 1.1  This practice covers the methods of calculating areas, volumes, and linear changes of irregularly shaped refractory specimens.
 1.2  The specimens must have a constant cross-sectional area over a length ( L ).
 1.3  The values stated in SI units are to be regarded as the standard.
 1.4   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 1.5   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM C1407-23 PDF

ASTM C1407-23 PDF

$32.00 $64.00