ASTM D1125-23 PDF

ASTM D1125-23 PDF

Standard Test Methods for Electrical Conductivity and Resistivity of Water

$36.00 $72.00 -50%
Product Code: ASTM D1125
Stock In Stock
Published: 2023
Number of Pages: 8

Available Options

Product Description

Significance and Use
 4.1  These test methods are applicable for such purposes as impurity detection and, in some cases, the quantitative measurement of ionic constituents dissolved in waters. These include dissolved electrolytes in natural and treated waters, such as boiler water, boiler feedwater, cooling water, and saline and brackish water.
 4.1.1  Their concentration may range from trace levels in pure waters ( 2 ) 4 to significant levels in condensed steam (see Test Methods D2186 and D4519 , and Ref ( 3 ) ), or pure salt solutions.
 4.1.2  Where the principal interest in the use of conductivity methods is to determine steam purity, see Ref ( 4 ) . These test methods may also be used for checking the correctness of water analyses ( 5 ) .
 Scope
 1.1  These test methods cover the determination of the electrical conductivity and resistivity of water. The following test methods are included:
 Range
 Sections
 Test Method A—Field and Routine Laboratory
 10 to 200 000
 12 to 18
  Measurement of Static (Non-Flowing) Samples
  μS/cm
 Test Method B—Continuous In-Line Measure
 5 to 200 000
 19 to 23
  ment
  μS/cm
 1.2  These test methods have been tested in reagent water. It is the user's responsibility to ensure the validity of these test methods for waters of untested matrices.
 1.3  For measurements below the range of these test methods, refer to Test Method D5391 .
 1.4  The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
 1.5   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 1.6   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM D1125-23 PDF

ASTM D1125-23 PDF

$36.00 $72.00