ASTM D115-17(2024) PDF

ASTM D115-17(2024) PDF

Standard Test Methods for Testing Solvent Containing Varnishes Used for Electrical Insulation

$36.00 $72.00 -50%
Product Code: ASTM D115
Stock In Stock
Published: 2024
Number of Pages: 9

Available Options

Product Description

Significance and Use
 4.1   Control— The following tests are useful for control purposes during the manufacture and use of varnishes, and for determining the uniformity of batches:
 4.1.1  Specific gravity,
 4.1.2  Viscosity,
 4.1.3  Flash point, and
 4.1.4  Nonvolatile matter by weight.
 4.2   Performance— The following tests are useful for determining the performance of varnishes during application and use:
 4.2.1  Drainage,
 4.2.2  Time of drying,
 4.2.3  Build,
 4.2.4  Dielectric strength,
 4.2.5  Thermal endurance,
 4.2.6  Varnish compatibility,
 4.2.7  Salt water proofness, and
 4.2.8  Oil resistance.
 Scope
 1.1  These test methods cover tests for solvent containing varnishes primarily intended to provide electrical, mechanical, and chemical protection for electrical equipment. These test methods include tests for control and performance as follows:
 Procedure
 Section
 Build
 38 – 42
 Dielectric Strength
 43 – 48
 Drainage
 26 – 32
 Flash Point
 18 – 20
 Nonvolatile Matter
 21 – 25
 Oil Resistance
 54 – 56
 Preparation of Test Specimens
      7
 Specific Gravity
   9 – 12
 Temperature Index
 49 – 50
 Time of Drying
 33 – 37
 Varnish Compatibility
 51 – 53
 Viscosity
 13 – 17
 1.2  Where the entire test method is included in this standard, the precision and bias are not known unless given in the stated method.
 1.3  The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
 1.4   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 5 .
 Note 1:   There is no equivalent IEC standard.
 1.5   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM D115-17(2024) PDF

ASTM D115-17(2024) PDF

$36.00 $72.00