ASTM D2229-24 PDF

ASTM D2229-24 PDF

Standard Test Method for Adhesion Between Steel Tire Cords and Rubber

$36.00 $72.00 -50%
Product Code: ASTM D2229
Stock In Stock
Published: 2024
Number of Pages: 7

Available Options

Product Description

Significance and Use
 5.1  This test method is considered satisfactory for the acceptance testing of commercial shipments of steel tire cord because current estimates of between-laboratory precision for single materials are considered acceptable and the method has been used extensively in the trade for acceptance testing.
 5.1.1  If there are differences or practical significances between reported test results for two laboratories (or more), comparative tests should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, the test samples should be used that are as homogenous as possible, that are drawn from the material from which the disparate test results were obtained, and that are randomly assigned in equal numbers to each laboratory for testing. Other materials with established test values may be used for this purpose. The test results from the two laboratories should be compared using a statistical test for unpaired data, at a probability level chosen prior to the testing series. If a bias is found, either its cause must be found and corrected, or future test results must be adjusted in consideration of the known bias.
 5.2   The mold described in this test method is primarily designed for quality acceptance testing for steel cord where the sample size for each cord is 4 or a multiple thereof, but any mold/cavity combination which will provide the required test block dimensions ( Figs. 1 and 2 ) is acceptable.
   Except where noted
 Note 1:   All dimensions in millimetres except where noted.
 Note 2:   Material—Mild steel.
 Note 3:   Mold should be coated permanently with a polytetrafluoro-ethylene, such as Teflon®, or preferably, with a stainless steel reinforced polytetrafluoro-ethylene with a polyamid binder, such as Excalibur®. 4
 Note 4:   Dimensions with “*” may be altered to accommodate test grips.
 5.3   Appendix X1 contains suggested ranges of environmental conditions for aging tests.
 5.4  The property measured by this test method indicates whether the adhesion of the steel cord to the rubber is greater than the cohesion of the rubber, that is, complete rubber coverage of the steel cord, or less than the cohesion of the rubber, that is, lack of rubber coverage.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM D2229-24 PDF

ASTM D2229-24 PDF

$36.00 $72.00