ASTM D244-23 PDF

ASTM D244-23 PDF

Standard Test Methods and Practices for Emulsified Asphalts

$36.00 $72.00 -50%
Product Code: ASTM D244
Stock In Stock
Published: 2023
Number of Pages: 9

Available Options

Product Description

Significance and Use
 5.1  This test method measures the amount of water present in the emulsified asphalt, as distinguished from either bitumen or petroleum solvent.
 Scope
 1.1  These test methods and practices, given under the headings titled Composition, Consistency, Stability, and Examination of Residue, cover the examination of asphalt emulsions composed principally of a semisolid or liquid asphaltic base, water, and an emulsifying agent. The test methods cover the following tests and practices:
 Test
 Sections
 Composition:
  Water Content
 4 – 10
  Residue and Oil Distillate by Distillation
 See Test Method
 D6997
  Residue by Evaporation
 See Test Method
 D6934
  Particle Charge of Cationic Emulsified Asphalts
 See Practice
 D7402
 Consistency:
  Viscosity (Saybolt Furol)
 See Test Method
 D7496
 Stability:
  Demulsibility
 See Test Method
 D6936
  Settlement
 See Test Method
 D6930
  Cement Mixing
 See Test Method
 D6935
  Sieve Test
 See Test Method
 D6933
  Aggregate Coating
 See Practice
 D6998
  Miscibility with Water
 See Practice
 D6999
  Freezing
 See Practice
 D6929
  Coating Ability and Water Resistance
 11 – 18
  Storage Stability of Asphalt Emulsion
 See Test Method
 D6930
 Examination of Residue
 19 – 26
 Identification Test for Rapid Setting Cationic Emulsified Asphalt
   27 – 34
 Identification of Cationic Slow Set Emulsions
 See Practice
 D7402
 Field Coating Test on Emulsified Asphalts
 35 – 40
 Emulsified Asphalt/Job Aggregate Coating Test
 41 – 46
 Density of Emulsified Asphalt
 See Test Method
 D6937
 Residue by Low-Temperature Vacuum Distillation
 See Test Method
 D7403
 1.2  The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
 1.3   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 1.4   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM D244-23 PDF

ASTM D244-23 PDF

$36.00 $72.00