ASTM D3930-08(2023) PDF

ASTM D3930-08(2023) PDF

Standard Specification for Adhesives for Wood-Based Materials for Construction of Manufactured Homes

$40.00 $80.00 -50%
Product Code: ASTM D3930
Stock In Stock
Published: 2023
Number of Pages: 19

Available Options

Product Description

This specification provides the means to measure and evaluate the performance of adhesives for structural or semistructural bonding of wood-to-wood in manufactured homes. Wood as used in this specification includes lumber, plywood, particleboard, gypsum board, and all materials having woodbased surfaces at the bondline. The adhesives can be classified according to resistance to deformation: Group A or structural, and Group B or semistructural. Also, the adhesives may be designated into three types, according to their recommended use based on their resistance to water and water vapor: Type 1 for interior and exterior use, Type 2 for weather-protected interior use, and Type 3 for interior use only. Different tests shall be performed in order to determine the following properties of adhesives: shear strength, gap-filling ability, total deformation resistance, moisture and temperature limitation during fabrication, high-temperature resistance, low-temperature resistance, moisture resistance, aging, oxidation resistance, and mold resistance.
 Scope
 1.1  This specification provides the means to measure and evaluate the performance of adhesives for structural or semi-structural bonding of wood-to-wood in manufactured homes. Wood as used in this specification includes lumber, plywood, particleboard, gypsum board, and all materials having wood-based surfaces at the bondline. This specification does not cover other adhesives used in manufactured homes such as adhesives for carpet, floor tile, ceramic fixtures, plastic laminates, trim and millwork, and similar nonstructural applications.
 1.1.1  The performance of the adhesives is measured in the following tests:
 Number
 Test
 Section
  1
 Low Temperature
 16
  2
 Dry Lumber
 17
  3
 Gap-Filling
 18
  4
 High Temperature
 19
  5
 Type 3 Qualification
 20
  6
 Type 2 Qualification
 21
  7
 Aging, Film Oxidation
 22
  8
 Aging, Bond Oxidation
 23
  9
 Resistance to Deformation, Creep
 24
 10
 Mold
 25
 11
 Type 1 Qualification
 26
 1.2  The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
 1.3   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 1.4   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM D3930-08(2023) PDF

ASTM D3930-08(2023) PDF

$40.00 $80.00