ASTM D470-21 PDF

ASTM D470-21 PDF

Standard Test Methods for Crosslinked Insulations and Jackets for Wire and Cable

$52.00 $104.00 -50%
Product Code: ASTM D470
Stock In Stock
Published: 2021
Number of Pages: 24

Available Options

Product Description

Significance and Use
 5.1  Physical tests, properly interpreted, provide information with regard to the physical properties of the insulation or jacket. The physical test values give an approximation of how the insulation will physically perform in its service life. Physical tests provide useful data for research and development, engineering design, quality control, and acceptance or rejection under specifications.
 Scope
 1.1  These test methods cover procedures for testing crosslinked insulations and jackets for wire and cable. To determine the test to be made on the particular insulation or jacket, refer to the product specification for that type. These test methods do not apply to the class of products known as flexible cords.
 1.2  In many instances the insulation or jacket cannot be tested unless it has been formed around a conductor or cable. Therefore, tests are done on insulated or jacketed wire or cable in these test methods solely to determine the relevant property of the insulation or jacket and not to test the conductor or completed cable.
 1.3  These test methods appear in the following sections:
 Test Method
 Section(s)
 AC and DC Voltage Withstand Tests
 22 to 29
 Capacitance and Dissipation Factor Tests
 38 to 44
 Cold Bend
 124
 Cold Bend, Long-time Voltage Test on Short Specimens
 51 to 57
 Double AC Voltage Test on Short Specimens
 45 to 50
 Electrical Tests of Insulation
 17 to 64
 Heat Distortion Test
 123
 Horizontal Flame Test
 100 (Test Method D7936 )
 Insulation Resistance Tests on Completed Cable
 30 to 37
 Mineral Filler Content, Determination of
 107 to 111
 Ozone Resistance Test
 87 to 99
 Partial-Discharge Test
 58 to 64
 Physical Tests of Insulation and Jacket Compounds
   5 to 16
 Surface Resistivity Test
 112 to 116
 Track Resistance Test
 125 to 128
 U-Bend Discharge Test
 117 to 121
 Water Absorption Test
 65 to 71
 Water Absorption Test, Accelerated
 72 to 86
 Water Absorption Test on Fibrous Coverings
   101 to 106
 1.4  Whenever two sets of values are presented, in different units, the values in the first set are the standard, while those in the parentheses are for information only.
 1.5   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazards see Section 4 .
 1.6   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM D470-21 PDF

ASTM D470-21 PDF

$52.00 $104.00