ASTM D5573-99(2019) PDF

ASTM D5573-99(2019) PDF

Standard Practice for Classifying Failure Modes in Fiber-Reinforced-Plastic (FRP) Joints

$32.00 $64.00 -50%
Product Code: ASTM D5573
Stock In Stock
Published: 2019
Number of Pages: 3

Available Options

Product Description

Significance and Use
 4.1  This practice provides a simple means of classifying failure modes for adhesively bonded FRP joints.
 4.2  Each failure mode classification is based solely on a visual observation of the failure surface without the aid of a microscope or other means to magnify the surface.
 4.3  Except for the line-drawing representations given, this practice does not contain descriptions of failure modes possible when using adhesion promoters. However, similar analogies to the failure modes described herein can be made.
 4.4  This practice does not address the acceptability of any specific failure mode.
 Scope
 1.1  This practice covers the method of classifying, identifying, and characterizing the failure modes in adhesively bonded fiber-reinforced-plastic (FRP) joints. The FRP used in developing this practice consists of glass fibers in a thermoset-polyester-resin matrix, commonly referred to as sheet-molding compound, or SMC.
 1.2  One objective of this practice is to present comprehensive definitions of possible failure modes to serve as a guide for contracts, drawings, product specifications, and product performance.
 Note 1:   Figures 2 through 11 referred to in the practice are contained in the ASTM adjunct, Color Photographs of Failure Modes. 2
 Fig. 2—Side-by Side Comparison of Failure Modes
 Fig. 3—Adhesive Failure
 Fig. 4—Cohesive Failure
 Fig. 5—Thin-Layer Cohesive Failure
 Fig. 6—Fiber-Tear Failure
 Fig. 7—Light-Fiber-Tear Failure
 Fig. 8—Stock-Break Failure
 Fig. 9—Mixed Failure—40 % Fiber-Tear Failure, 60 % Light-Fiber-Tear Fiber
 Fig. 10—Mixed Failure—32 % Adhesive Failure, 68 % Fiber-Tear Failure
 Fig. 11—Mixed Failure—20 % Adhesive Failure, 60 % Light-Fiber-Tear Failure, 20 % Fiber-Tear Failure
 Note 2:   This practice may be used to describe the failure modes generated from testing, using procedures such as Test Methods D3163 , D3164 , D3165 , D3807 , D5041 , D5868 , and SAE J1525.
 1.3  The values stated in SI units are to be regarded as the standard.
 1.4   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 1.5   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM D5573-99(2019) PDF

ASTM D5573-99(2019) PDF

$32.00 $64.00