ASTM D619-21 PDF

ASTM D619-21 PDF

Standard Test Methods for Vulcanized Fibre Used for Electrical Insulation

$36.00 $72.00 -50%
Product Code: ASTM D619
Stock In Stock
Published: 2021
Number of Pages: 8

Available Options

Product Description

These test methods details the standard procedures for testing certain properties of vulcanized fibre sheets, tubes, and rods of such grades as can be used for electrical insulation. Arc resistance, ash content, bond strength (ply adhesion), bursting strength, compressive strength, conditioning, density, dielectric strength, dimensional measurements, flammability, flexural strength, silica content, tearing strength, tensile strength, thickness (for sheets), resistance to impact, Rockwell hardness, volatile matter content, water absorption, and zinc chloride content are among the properties that these test methods shall be able to examine.
 Scope
 1.1  These test methods cover the procedures for testing vulcanized fibre sheets, rolls, tubes, and rods of such grades as can be used for electrical insulation.
 1.2  The procedures appear in the following sections:
 Procedure
 Section
 Arc Resistance
 23
 Ash
 6
 Bond Strength (Ply Adhesion)
 16
 Bursting Strength
 14
 Compressive Strength
 12 , 25 , 30
 Conditioning
 4
 Density
 17 , 26 , 32
 Dielectric Strength
 18 , 27
 Dimensional Measurements
 28 , 33
 Flammability
 22
 Flexural Strength
 13 , 31
 Silica
 7
 Tearing Strength
 11
 Tensile Strength
 10 , 24 , 29
 Thickness (Sheets)
 20
 Resistance to Impact
 15
 Rockwell Hardness
 19
 Volatile Matter
 8
 Water Absorption
 5
 Zinc Chloride
 9
 1.3  The values stated in inch-pound units are to be regarded as the standard. The SI values given in parentheses are for information only.
 1.4   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in 7.3 , 22.1 , and 22.2 .
 Note 1:   The test methods described herein are similar technically to those described in IEC Publication 60667-2. Not all of the tests in this document are included in IEC 60667-2, and the procedures in the two publications are not completely identical; but it is expected that comparable results will be obtained from most of the procedures. Conduct comparative tests if necessary before directly comparing results of tests using the different procedures.
 1.5   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM D619-21 PDF

ASTM D619-21 PDF

$36.00 $72.00