ASTM D7834-13(2024) PDF

ASTM D7834-13(2024) PDF

Standard Test Method for Filling Material Shedding of Paint Brushes

$32.00 $64.00 -50%
Product Code: ASTM D7834
Stock In Stock
Published: 2024
Number of Pages: 2

Available Options

Product Description

Significance and Use
 3.1  During the application of coatings, paint brushes can exhibit shedding of filling material onto the coated surface. A measure of this shedding filling material will determine the paint brush’s ability to resist shedding during application.
 Scope
 1.1  This test method describes the procedure for testing the shedding properties of both natural bristle and synthetic filament paint brushes (referred as filling material).
 1.2  The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
 1.3   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 1.4   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM D7834-13(2024) PDF

ASTM D7834-13(2024) PDF

$32.00 $64.00