ASTM E154/E154M-08A(2025) PDF

ASTM E154/E154M-08A(2025) PDF

Standard Test Methods for Water Vapor Retarders Used in Contact with Earth Under Concrete Slabs, on Walls, or as Ground Cover

$36.00 $72.00 -50%
Product Code: ASTM E154/E154M
Stock In Stock
Published: 2025
Number of Pages: 7

Available Options

Product Description

Significance and Use
 4.1  In service, vapor retarders may be exposed to a variety of conditions, so no one test will provide evaluations related to performance for all exposures (refer to Guide E241 and Practice C755 ). Neither will all test methods listed be necessary in all evaluations for specific exposures (see 16.2 ).
 4.2   Limitations— Prior to use and in service, vapor retarders may be exposed to a variety of conditions so no one test will provide evaluations related to performance for all exposures (refer to Guide E241 and Practice C755 ). Neither will all tests be necessary in all evaluations for specific exposures. Consequently, the tests and required test results shall be agreed upon by the purchaser and the supplier (see 16.2 ).
 Scope
 1.1  These test methods 2 cover the determination of the properties of flexible membranes to be used as vapor retarders in contact with earth under concrete slabs, against walls, or as ground cover in crawl spaces. The test methods are applicable primarily to plastic films and other flexible sheets. The materials are not intended to be subjected to sustained hydrostatic pressure. The procedures simulate conditions to which vapor retarders may be subjected prior to and during installation, and in service.
 1.2  The test methods included are:
 Section
 Water-Vapor Transmission of Material as Received
   7
 Water-Vapor Transmission after Wetting and Drying and after Long-  Time Soaking
   8
 Tensile Strength
   9
 Resistance to Puncture
 10
 Resistance to Plastic Flow and Elevated Temperature
 11
 Effect of Low Temperatures on Flexibility
 12
 Resistance to Deterioration from Organisms and Substances in Con-  tacting Soil
 13
 Resistance to Deterioration from Petroleum Vehicles for Soil Poisons
 14
 Resistance to Deterioration from Exposure to Ultraviolet Light
 15
 Resistance to Flame Spread
 16
 Report
 17
 1.3  The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
 1.4   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 1.5   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM E154/E154M-08A(2025) PDF

ASTM E154/E154M-08A(2025) PDF

$36.00 $72.00