ASTM F734-17(2022) PDF

ASTM F734-17(2022) PDF

Standard Test Method for Shear Strength of Fusion Bonded Polycarbonate Aerospace Glazing Material

$36.00 $72.00 -50%
Product Code: ASTM F734
Stock In Stock
Published: 2022
Number of Pages: 5

Available Options

Product Description

Significance and Use
 5.1  At this writing, aerospace quality extruded transparent polycarbonate material is not available in thicknesses greater than 0.5 in. (12.7 mm). When a requirement exists for sheets thicker than 0.5 in. (12.7 mm), two or more sheets are fusion bonded together to form a single sheet of the desired thickness.
 5.2  The structural integrity of the completed transparency depends on the integrity of the fusion bond. This test applies torsional shear loads to measure the structural integrity of the fusion bond. This test method is considered more reliable and more reproducible than shear tests in tension or compression.
 Scope
 1.1  This test method determines the shear yield strength F s y and shear ultimate strength F s u of fusion bonds in polycarbonate by applying torsional shear loads to the fusion-bond line.
 1.2   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 1.3   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM F734-17(2022) PDF

ASTM F734-17(2022) PDF

$36.00 $72.00