ASTM B467-14(2022) PDF

ASTM B467-14(2022) PDF

Standard Specification for Welded Copper-Nickel Pipe

$36.00 $72.00 -50%
Product Code: ASTM B467
Stock In Stock
Published: 2022
Number of Pages: 8

Available Options

Product Description

Significance and Use
 18.1  For purposes of determining compliance with the specified limits for requirements of the properties listed in the following table, and observed value or a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29 .
 Property
 Rounded Unit for Observed or Calculated Value
 Chemical composition
 nearest unit in the last right-hand place of figures of the specified limit
 Tensile strength Yield strength
 nearest ksi (nearest MPa up to 10 ksi, incl, nearest 5 MPa over 10 ksi)
 Elongation
 nearest 1 %
 Abstract
 This specification covers welded copper-nickel alloy pipes produced from Copper Alloy UNS Nos. C70600 and C71500 for general engineering applications. Pipes may be produced in any one of the following tempers: as-welded from annealed sheets, strips, or plates (WM50); as-welded from cold-worked sheets, strips, or plates (WM00, WM01, WM02, and so forth); welded and annealed (WO50); welded, light cold drawn (WR00) or hard cold drawn (WR04), and stress relieved; or fully finished as annealed, light drawn (WH00) or hard drawn (WH04), and stress relieved. Products shall be sampled and prepared, then tested accordingly to examine their conformance to dimensional (outside diameter, specific and stock lengths, wall thickness, squareness of cut, and roundness), mechanical (tensile and yield strengths, and elongation), and chemical composition requirements. Specimens shall also undergo nondestructive tests such as radiographic examination, eddy-current test, and hydrostatic test.
 Scope
 1.1  This specification establishes the requirements for welded copper-nickel alloy pipe for general engineering purposes. The following alloys are covered: 2
 Copper Alloy UNS No. 2
 Type of Metal
 C70600
 90-10 copper-nickel
 C70620
 90-10 copper-nickel
 (Modified for Welding)
 C71500
 70-30 copper-nickel
 C71520
 70-30 copper-nickel
 (Modified for Welding)
 1.2   Units— The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
 1.3   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM B467-14(2022) PDF

ASTM B467-14(2022) PDF

$36.00 $72.00