ASTM D204-02(2021) PDF

ASTM D204-02(2021) PDF

Standard Test Methods for Sewing Threads

$40.00 $80.00 -50%
Product Code: ASTM D204
Stock In Stock
Published: 2021
Number of Pages: 13

Available Options

Product Description

Significance and Use
 4.1   Acceptance Testing— The test methods in Test Methods D204 for the determination of the properties of sewing thread are considered satisfactory for acceptance testing of commercial shipments of sewing thread, unless specified in the individual test method. These test methods are the best available and are used extensively in the trade.
 4.1.1  If there are differences of practical significance between reported test results for two laboratories (or more) comparative test should be performed to determine if there is a statistical bias between them using competent statistical assistance. As a minimum, use the samples for such a comparative tests that are as homogeneous as possible, drawn from the same lot of material as the samples that resulted in disparate results during initial testing and randomly assigned in equal numbers to each laboratory. The test results from the laboratories involved should be compared using a statistical test for unpaired data, a probability level chosen prior to the testing series. If a bias is found, either its cause must be found and corrected, or future test results for that material must be adjusted in consideration of the known bias.
 Scope
 1.1  These test methods can be used to evaluate sewing threads of any fiber.
 1.1.1  The test methods in this standard are intended to evaluate only sewing thread taken from thread holders.
 1.2  These test methods only provide for the measurement of sewing thread physical properties. These test methods do not address any other properties that may be important for the satisfactory performance of sewing threads under particular end use conditions.
 1.3  These test methods can be used to measure the following properties:
 Sections
 Colorfastness to Drycleaning
 73 – 83
 Colorfastness to Laundering
 62 – 72
 Colorfastness to Water Migration
 84 – 94
 Diameter
 43 – 50
 Length per Thread Holder
 34 – 42
 Shrinkage, Single Strand
 51 – 61
  Dry Heat
 58.1
  Boiling Water
 58.2
 Strength and Elongation
 15 – 21
  Single Strand—Conditioned
 19.1.1
  Single Strand—Wet
 19.1.2
  Loop Strength
 19.2
  Knot Strength
 19.3
 Twist
 22 – 27
 Twist Balance
 28 – 33
 Yarn Number
 7 – 14
 Note 1:   For methods covering tests on prepared seams, refer to Test Methods D1683/D1683M and D3940 .
 1.4  The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.
 1.5   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 1.6   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM D204-02(2021) PDF

ASTM D204-02(2021) PDF

$40.00 $80.00