ASTM D2305-18 PDF

ASTM D2305-18 PDF

Standard Test Methods for Polymeric Films Used for Electrical Insulation

$36.00 $72.00 -50%
Product Code: ASTM D2305
Stock In Stock
Published: 2018
Number of Pages: 8

Available Options

Product Description

Significance and Use
 6.1  Many electrical and physical properties of films vary significantly with changes in temperature and humidity. Properties of thin plastic films can change very rapidly; therefore, the specimen needs to be in the stated conditioning environment when the test is being performed. When the test is performed in a different environment, note these conditions and the time of exposure to this new environment.
 Scope
 1.1  These test methods cover the testing of homogeneous organic polymer films not over 2.4 mm (95 mils) thick that are to be used for electrical insulation.
 1.2  These test methods are not necessarily applicable to testing films in combinations with a coating, another film, or with other types of substrate, such as fabrics or papers.
 1.3  The values stated in SI units are the standard. The values in parentheses are provided for information only.
 1.4  The procedures appear in the following sections:
 Procedure
 Sections
 Conditioning
   6 and 7
 Dielectric Breakdown Voltage & Dielectric Strength
 21 to 26
 Extractables
 65 to 70
 Heat-Seal Strength
 59 to 64
 Permittivity and Dissipation Factor
 42 to 47
 Resistance Method for Measuring the Tendency to
  Corrode Metals
 38 to 41
 Sampling
 5
 Shrinkage
 48 to 53
 Strain Relief
 13 to 20
 Surface Resistivity
 27 to 31
 Tensile Properties
 12
 Thickness
   8 to 11
 Volume Resistivity
 32 to 37
 Water Absorption
 53 to 58
 1.5   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 Note 1:   These test methods are similar to IEC 60674–2.
 1.6   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM D2305-18 PDF

ASTM D2305-18 PDF

$36.00 $72.00