ASTM D4041/D4041M-05(2025) PDF

ASTM D4041/D4041M-05(2025) PDF

Standard Practice for Determining Spray Patterns of Mechanical Pump Dispensers

$32.00 $64.00 -50%
Product Code: ASTM D4041/D4041M
Stock In Stock
Published: 2025
Number of Pages: 3

Available Options

Product Description

Significance and Use
 4.1  This practice can be used to compare spray patterns of different pump dispensers and of different products.
 4.2  Spray patterns from pump dispensers will vary greatly with the design of the actuator and the nature of the liquid. Liquids with differing physical properties will not necessarily yield the same spray pattern when sprayed from the same actuator. Likewise, actuators of different designs will yield spray patterns distinct from each other when the same liquid is used.
 Scope
 1.1  This practice covers the determination of spray patterns from pump dispensers.
 1.2  The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
 1.3   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 1.4   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM D4041/D4041M-05(2025) PDF

ASTM D4041/D4041M-05(2025) PDF

$32.00 $64.00