ASTM D500-95(2023) PDF

ASTM D500-95(2023) PDF

Standard Test Methods of Chemical Analysis of Sulfonated and Sulfated Oils

$40.00 $80.00 -50%
Product Code: ASTM D500
Stock In Stock
Published: 2023
Number of Pages: 12

Available Options

Product Description

These test methods cover the chemical analysis of sulfonated and sulfated oils. Water by distillation with volatile solvent and moisture and volatile matter by hot-plate shall be tested to meet the requirements prescribed. Titration test, extraction-titration test, and ash-gravimetric test shall be performed to meet the requirements specified. Total desulfated fatty matter, total active ingredients, unsaponifiable non-volatile matter, inorganic salts, total alkalinity, and total ammonia shall be tested to meet the requirements prescribed. In the absence of ammonium or triethanolamine soaps test method, brine test method, and in the presence of ammonium or triethanolamine soaps test method shall be performed to meet the requirements prescribed. Water-immiscible organic solvents volatile with steam shall be tested to meet the requirements prescribed.
 Scope
 1.1  These test methods cover the chemical analysis of sulfonated and sulfated oils. The analytical procedures appear in the following order:
 Section
 Moisture:
  Test Method A. Water by Distillation with Volatile Solvent
 4 – 9
  Test Method B. Moisture and Volatile Matter by Hot-Plate Method
 10 – 14
 Organically Combined Sulfuric Anhydride:
  Test Method A. Titration Test
 15 – 19
  Test Method B. Extraction-Titration Test
 20 – 24
  Test Method C. Ash-Gravimetric Test (in the Presence of True Sulfonates)
 25 – 28
 Total Desulfated Fatty Matter
 29 – 32
 Total Active Ingredients
 33 – 36
 Unsaponifiable Nonvolatile Matter
 37 – 41
 Inorganic Salts
 42 – 46
 Total Alkalinity
 47 – 49
 Total Ammonia
 50 – 52
 Acidity as Free Fatty Acids or Acid Number:
  Test Method A. In the Absence of Ammonium or Triethanolamine Soaps
 53 – 56
  Test Method B. In the Presence of Dark Colored Oils but in the Absence of Ammonium or Triethanolamine Soaps (Brine Test)
 57 – 60
  Test Method C. In the Presence of Ammonium or Triethanolamine Soaps
 61 – 63
 Water-Immiscible Organic Solvents Volatile with Steam
 64 – 70
 1.2  The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of inch-pound units may be approximate.
 1.3   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Material Safety Data Sheets are available for reagents and materials. Review them for hazards prior to usage.
 1.4   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM D500-95(2023) PDF

ASTM D500-95(2023) PDF

$40.00 $80.00