ASTM D7484-25a PDF

ASTM D7484-25a PDF

Standard Test Method for Evaluation of Automotive Engine Oils for Valve-Train Wear Performance in Cummins ISB Medium-Duty Diesel Engine

$52.00 $104.00 -50%
Product Code: ASTM D7484
Stock In Stock
Published: 2025
Number of Pages: 29

Available Options

Product Description

Significance and Use
 5.1  This test method was developed to assess the performance of a heavy-duty engine oil in controlling engine wear under operating conditions selected to accelerate soot production and valve-train wear in a turbocharged and aftercooled four-cycle diesel engine with sliding tappet followers equipped with exhaust gas recirculation hardware.
 5.2  The design of the engine used in this test method is representative of many, but not all, modern diesel engines. This factor, along with the accelerated operating conditions, shall be considered when extrapolating test results.
 Scope
 1.1  This test method, commonly referred to as the Cummins ISB Test, covers the utilization of a modern, 5.9 L, diesel engine equipped with exhaust gas recirculation and is used to evaluate oil performance with regard to valve-train wear.
 1.2  The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
 1.2.1   Exceptions— SI units are provided for all parameters except where there is no direct equivalent such as the units for screw threads, National Pipe Threads/diameters, tubing size, or where there is a sole source of supply equipment specification.
 1.2.2  See also A7.1 for clarification; it does not supersede 1.2 and 1.2.1 .
 1.3   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See Annex A1 for general safety precautions.
 1.4   Table of Contents:  
 Section
 Scope
 1
 Referenced Documents
 2
 Terminology
 3
 Summary of Test Method
 4
 Significance and Use
 5
 Apparatus
 6
 Engine Fluids and Cleaning Solvents
 7
 Preparation of Apparatus
 8
 Engine/Stand Calibration and Non-Reference Oil Tests
 9
 Test Procedure
 10
 Calculations, Ratings, and Test Validity
 11
 Report
 12
 Precision and Bias
 13
 Annexes
 Safety Precautions
 Annex A1
 Intake Air Aftercooler
 Annex A2
 The Cummins ISB Engine Build Parts Kit
 Annex A3
 Sensor Locations and Special Hardware
 Annex A4
 External Oil System
 Annex A5
 Cummins Service Publications
 Annex A6
 Specified Units and Formats
 Annex A7
 Oil Analyses
 Annex A8
 Alternate Fuel Approval Process
 Annex A9
 1.5   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM D7484-25a PDF

ASTM D7484-25a PDF

$52.00 $104.00