ASTM D8148-26 PDF

ASTM D8148-26 PDF

Standard Test Method for Spectroscopic Determination of Haze in Fuels

$40.00 $80.00 -50%
Product Code: ASTM D8148
Stock In Stock
Published: 2026
Number of Pages: 11

Available Options

Product Description

Significance and Use
 5.1  It has long been the practice to include in fuel specifications a requirement that the fuel is clear and bright.
 5.2  One primary cause for failure to meet this specification requirement is the occurrence of a cloudy or hazy appearance caused by suspended solid particulates or water or some combination of both.
 5.2.1  This cloudiness or haze can range from barely visible to opaque.
 5.3  This test method provides two procedures that enable an objective analytical means for providing a haze rating that does not depend on subjective visual ratings that typically vary with operator and lighting conditions.
 Scope
 1.1  This test method covers two spectroscopic procedure for determining the level of suspended water and particulate contamination (haze) in liquid middle distillate fuels and gasolines including those blended with synthesized hydrocarbons or biofuels.
 1.1.1  Both procedures provide an ordinal, whole-number, Instrument Haze Rating (IHR) from 1 to 6 and a Haze Clarity Index (HCI) from 50.0 to 100.0.
 1.1.1.1  Procedure 1 provides a rapid pass/fail technique for test specimen temperatures from 6.0 °C to 38.0 °C ± 2.0 °C.
 1.1.1.2  Procedure 2 provides haze determinations at test specimen temperature of 22.0 °C ± 2.0 °C.
 1.1.1.3  The stated precision for these procedures only applies at the stated temperatures.
 1.1.1.4  Fuels analyzed at other test specimen temperatures may not have the same precision.
 1.2  The values stated in SI units are to be regarded as standard. Other units of measurement included in this standard are defined in Section 3 .
 1.3   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 1.4   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM D8148-26 PDF

ASTM D8148-26 PDF

$40.00 $80.00