ASTM D876-21 PDF

ASTM D876-21 PDF

Standard Test Methods for Nonrigid Vinyl Chloride Polymer Tubing Used for Electrical Insulation

$40.00 $80.00 -50%
Product Code: ASTM D876
Stock In Stock
Published: 2021
Number of Pages: 12

Available Options

Product Description

Significance and Use
 4.1  These test methods include most of the test methods that are considered important to characterize nonrigid vinyl chloride polymer tubing. While they were developed initially for this type of extruded tubing, their use is not limited to this type of tubing.
 4.2  Variations in these test methods or alternate contemporary methods are acceptable for use determine the values for the properties in this standard provided such methods ensure quality levels and measurement accuracy equal to or better than those prescribed herein. It is the responsibility of the organizations using alternate test methods to be able to demonstrate this condition. In cases of dispute, the test methods specified herein shall be used.
 Note 2:   Provision for alternate methods is necessary because of (1) the desire to simplify procedures for specific applications without altering the result, and (2) the desire to eliminate redundant testing and use data generated during manufacturing process control, including that generated under Statistical Process Control (SPC) conditions, using equipment and methods other than those specified herein. An example would be the use of laser micrometers or optical comparators to measure dimensions.
 Scope
 1.1  These test methods cover the testing of general-purpose (Grade A), low-temperature (Grade B), and high-temperature (Grade C) 2 nonrigid vinyl chloride polymer tubing, or its copolymers with other materials, for use as electrical insulation. For the purpose of these test methods nonrigid tubing shall be tubing having an initial elongation in excess of 100 % at break.
 Note 1:   These test methods are similar but not identical to those in IEC 60684–2.
 1.2  The values stated in inch-pound units are to be regarded as standard, except for temperature, which shall be expressed in degrees Celsius. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
 1.3  The procedures appear in the following sections: Procedure Section
 ASTM Reference Standard
 Brittleness Temperature
 37 – 39
 D746
 Corrosion Tests
 68 – 79
   D1000
 Dielectric Breakdown Voltage at High Humidity
 59 – 67
 E104
 Dielectric Breakdown Voltage
 52 – 58
 D149
 Dimensional Tests
 8 – 14
 D374
 Effect of Elevated Temperatures
 19 – 30
 D412
 Flammability Test
 D8355 ,
 Test Method A
 Oil Resistance Test
 29 – 36
 D471
 Penetration Test
 40 – 45
 Sampling
 6
 Strain Relief Test
 62 – 67
 Tension Test
 16 – 18
 D412
 Test Conditions
 7
 Volume Resistivity
 46 – 51
 D257
 1.4   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 5 .
 1.5   For fire test caveats, see Test Methods D8355 .
 1.6   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM D876-21 PDF

ASTM D876-21 PDF

$40.00 $80.00