ASTM E2890-21 PDF

ASTM E2890-21 PDF

Standard Test Method for Determination of Kinetic Parameters and Reaction Order for Thermally Unstable Materials by Differential Scanning Calorimetry Using the Kissinger and Farjas Methods

$40.00 $80.00 -50%
Product Code: ASTM E2890
Stock In Stock
Published: 2021
Number of Pages: 12

Available Options

Product Description

Significance and Use
 6.1  This test method is useful for research and development, quality assurance, regulatory compliance and specification-based acceptance.
 6.2  The kinetic parameters determined by this method may be used to calculate thermal hazard figures-of-merit according to Practice E1231 .
 Scope
 1.1  This test method describes the determination of the kinetic parameters of Arrhenius activation energy and pre-exponential factor using the Kissinger variable heating rate iso-conversion method ( 1 , 2 ) 2 and activation energy and reaction order by the Farjas method ( 3 ) for thermally unstable materials. The test method is applicable to the temperature range from 300 K to 900 K (27 °C to 627 °C).
 1.2  Both n th order and accelerating reactions are addressed by this method over the range of 0.5 n p n is the n th order reaction order and p is the Avrami reaction order ( 4 ) . Reaction orders n and p are determined by the Farjas method ( 3 ) .
 1.3  This test method uses the same experimental conditions as Test Method E698 . The Flynn/Wall/Ozawa data treatment of Test Method E698 may be simultaneously applied to these experimental results.
 1.4  The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
 1.5   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 1.6   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM E2890-21 PDF

ASTM E2890-21 PDF

$40.00 $80.00