ASTM E316-25 PDF

ASTM E316-25 PDF

Standard Test Method for Determination of Iron in Manganese Ores by Hydrogen Sulfide Reduction-Dichromate Titrimetry

$32.00 $64.00 -50%
Product Code: ASTM E316
Stock In Stock
Published: 2025
Number of Pages: 3

Available Options

Product Description

Significance and Use
 5.1  This test method is intended to be used for compliance with compositional specifications for iron content in manganese ores. It is assumed that all who use these procedures will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that work will be performed in a properly equipped laboratory and that proper waste disposal procedures will be followed. Appropriate quality control practices must be followed such as those described in Guide E882 .
 Scope
 1.1  This test method covers the determination of iron in manganese ore from 2 % to 20 %.
 Note 1:   As used in this test method (except as related to the term relative standard deviation ), “percent” or “%” refers to mass fraction (wt/wt) of the form 1g/100g.
 1.2  The values stated in SI units are regarded as standard. No other units of measurement are included in this standard.
 1.3   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 1.4   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM E316-25 PDF

ASTM E316-25 PDF

$32.00 $64.00