ASTM E3187/E3187M-25 PDF

ASTM E3187/E3187M-25 PDF

Standard Specification for Less Lethal Aerosol Devices Used by Law Enforcement, Corrections, and Other Public Safety Officers

$36.00 $72.00 -50%
Product Code: ASTM E3187/E3187M
Stock In Stock
Published: 2025
Number of Pages: 8

Available Options

Product Description

Scope
 1.1  This specification addresses less lethal chemical irritant sprays used by law enforcement, corrections, and other public safety officers.
 1.2  This specification is limited to duty belt-mounted canisters.
 1.3  This specification is limited to sprays intended for use on humans.
 1.4  This specification defines requirements for products containing liquid aerosol Oleoresin Capsicum (OC) spray (that is, pepper spray), Orthochlorobenzalmalononitrile (CS) spray (that is, 2–chlorobenzylidenemalononitrile; CAS #: 2698-41-1), or OC-CS combination spray. The formulation may be delivered as a stream, gel, foam, cone, or vapor.
 1.5  This specification does not address incendiary devices or “hot gas.”
 1.6  Products covered by this specification may be flammable or nonflammable.
 1.7  Products covered by this specification are hazardous substances as defined by 16 CFR 1500.3.
 1.8  It is intended that the following related practice be used in conjunction with this specification: Practice E3215 .
 1.9   Units— The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
 1.9.1  For some quantities in Sections 9 , 10 , and 11 , only SI units are used to be consistent with industry practice.
 1.10   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 1.11   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM E3187/E3187M-25 PDF

ASTM E3187/E3187M-25 PDF

$36.00 $72.00