AWWA C901-2025 PDF

AWWA C901-2025 PDF

Polyethylene (PE) Pressure Pipe and Tubing, 3/4 In. (19 mm) Through 3 In. (76 mm), for Water Service

$71.00 $142.00 -50%
isbn 9781613007808
Product Code: AWWA C901
Stock In Stock
Published: 07/01/2025
Number of Pages: 40
File Size: 1 file, 1 Byte

Available Options

Product Description

This standard describes polyethylene (PE) pressure pipe, tubing, and fittings, made from material having standard PE code designation PE4710 and intended for use in potable water, reclaimed water, and wastewater service. PE pipe ranges in nominal size from 3/4 in. (19 mm) through 3 in. (76 mm) and conforms to the outside-diameter (OD) dimensions of iron pipe size (IPS). PE tubing ranges in nominal size from 3/4 in. (19 mm) through 2 in. (51 mm) and conforms to the OD dimensions of copper tube size (CTS). Fittings are produced in both pipe and tubing sizes under this standard. Included in this standard are criteria for classifying PE plastic pipe materials, a system of nomenclature for PE plastic pipe, and requirements and test methods for materials, pipe, tubing, and fittings. Methods of marking are also given. For larger sizes up to 65 in. (1,650 mm), refer to ANSI/AWWA C906. This standard can be referenced when purchasing and receiving PE pressure pipe, tubing, and fittings, for use in potable water, wastewater, and reclaimed water systems. It can be used as a guide for manufacturing this type of pressure pipe and tubing. The stipulations of this standard apply when this document has been referenced and then only to 3/4 in. (19 mm) through 3 in. (76 mm) PE pipe and 3/4 in. (19 mm) through 2 in. (51 mm) tubing for potable water, wastewater, and reclaimed water service.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
AWWA C901-2025 PDF

AWWA C901-2025 PDF

$71.00 $142.00