Methods of test for soils for civil engineering purposes-General requirements and sample preparation
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 July 2016. It was prepared by Subcommittee B/526/3, Site investigation and ground testing, under the authority of Technical Committee B/526, Geotechnics. A list of organizations represented on these committees can be obtained on request to their secretary. Supersession This British Standard supersedes BS 1377-1:1990, which is withdrawn.
Information about this document: This new edition of BS 1377-1 incorporates technical changes only. It does not represent a full review or revision of the standard, which will be undertaken in due course.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Requirements in this standard are drafted in accordance with Rules for the structure and drafting of UK standards, subclause J.1.1, which states, “Requirements should be expressed using wording such as: ‘When tested as described in Annex A, the product shall ...’”. This means that only those products that are capable of passing the specified test will be deemed to conform to this standard.
Scope: This part of BS 1377 specifies general requirements for the testing of soils for civil engineering purposes and describes methods for the calibration of equipment and the preparation of test samples.
Contents:
- Introduction
- Scope
- Bibliography