Recycled mineral insulating oil for transformers and switchgear. Specification
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 March 2020. It was prepared by Technical Committee GEL/10, Fluids for electrotechnical applications. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This British Standard supersedes BS 148:2009, which is withdrawn.
Information about this document: The limits given in this British Standard are based on BS EN 60296. For ease of cross‑reference, the clause numbering of this standard follows that of BS EN 60296 as far as possible. This standard differs from BS EN 60296 in specifying limits for total furans. The increasing use of total furfural/ furans measurements as an in‑service diagnostic tool has brought about the necessity to impose limits on reclaimed oil, which is continued in this edition. This British Standard acknowledges UK practice whereby the limiting values for reclaimed mineral insulating oils are based on those for unused mineral insulating oils for transformers and switchgear while having due regard for the variability of used oil feedstock from which reclaimed oil is produced.
Use of this document: It has been assumed in the preparation of this British Standard that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Requirements in this standard are drafted in accordance with Rules for the structure and drafting of UK standards, subclause G.1.1, which states, “Requirements should be expressed using wording such as: ‘When tested as described in Annex A, the product shall ...’”. This means that only those products that are capable of passing the specified test will be deemed to conform to this standard.
Scope: This British Standard specifies requirements for recycled oxidation inhibited and uninhibited mineral insulating oils, as delivered, for use in transformers, switchgear and similar electrical equipment in which oil is required as an insulant and/or for heat transfer. Oils with and without additives are within the scope of this standard. This standard does not differentiate between methods used to recycle used mineral insulating oil, thus reclaimed or regenerated oil, re-refined oil, dechlorinated oil and reconditioned oil are all considered recycled oil for the purposes of this standard. This standard does not apply to mineral insulating oils used as impregnates in cables or capacitors, or to hydrocarbon insulating liquids obtained by synthesis. NOTE Oils conforming to the requirements of this standard, and containing no additives, are considered to be compatible with one another and can be mixed in any proportion. This does not necessarily apply to oils containing additives, and where the user wishes to mix such oils a check should be made to ensure that the mixture conforms to the requirements of this standard.