Specification for identification of pipelines and services
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 December 2014. It was prepared by Technical Committee PSE/4, Identification of piping systems. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This British Standard supersedes BS 1710:1984, which is withdrawn.
Information about this document: This is a full revision of the standard and introduces the following principal changes: the labelling system has been refined; ship systems have been removed; the water systems section has been amended and the labelling for water services expanded; and colour coding and sizing of markings reviewed and amended.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This British Standard specifies the colours and supplementary information for the identification of pipes conveying fluids in above ground and below ground installations. It also includes ducts for ventilation and conduits used for carrying electrical services. The following two methods of identification are included: a) basic identification colours only; and b) basic identification colours and code indications and/or code colours. NOTE 1 Examples of identification by basic colour and code indications are illustrated in Annex A. NOTE 2 The marking and labelling requirements identified in this British Standard are the preferred methods where there is no British Standard that covers a specific pipe or pipeline sector. This British Standard does not include identification of fluid services on ships. NOTE 3 For piping systems on ships and marine technology applications, see BS ISO 14726.
Contents:
- Foreword
- Scope
- Annexes
- Annex A (informative) Basic identification and code indications
- Annex B (informative) Information on pipe contents
- Annex C (normative) Medical gas applications
- Annex D (normative) Code colours for general building services
- Annex E (normative) Code colours for refrigeration services
- Annex F (normative) Water services
- Bibliography