BS 1868-1975+A1-1990 PDF

BS 1868-1975+A1-1990 PDF

Specification for steel check valves (flanged and butt-welding ends) for the petroleum, petrochemical and allied industries

$147.32 $294.64 -50%
Publisher
isbn 9780580703195
Product Code: BS 1868
Stock In Stock
Published: 01/31/2010
Number of Pages: 28
File Size: 1 file, 890 KB

Available Options

Product Description

Specification for steel check valves (flanged and butt-welding ends) for the petroleum, petrochemical and allied industries

Scope: This British Standard specifies requirements for cast or forged steel check valves with flanged or butt-welding ends of the following types: a) swing, for vertical or horizontal flow (see Figure 1); b) lift: i) piston type, for angle or horizontal flow (see Figure 2); ii) ball type, for angle or horizontal flow (see Figure 3); iii) ball type, for vertical flow (see Figure 4); iv) disk type, for vertical flow (see Figure 5). The terms “vertical”, “horizontal” and “angle” relate to the axes of the body ends. When swing check valves are used in vertical lines the flow must be in an upward direction. For the purposes of this standard any line with a slope (upward or downward) of 5° or less is deemed to be horizontal. In the case of angle pattern valves the inlet should be vertical. 2 References The titles of the British Standards referred to in this standard are listed on the inside back cover. 3 Definitions nominal size the nominal size (DN) is a numerical designation of size that is common to all components in a piping system other than those using valves, fittings, couplings or tubes that are designated by the outside diameter. It is a convenient round number for reference purposes and is normally only loosely related to manufacturing dimensions 4 Pressure classification This standard applies to valves of the following class designations: Classes 150, 300, 400, 600, 900, 1 500 and 2 500. The numerals in these class designations represent the primary pressure ratings of the valves in pounds force per square inch. 5 Pressure/temperature ratings The pressure/temperature ratings applicable to valves covered by this standard shall be in accordance with tables PE 1 to PE 12 as listed in BS 1560-2 for the particular shell material specified. There is, however, a temperature restriction on certain trim materials and soft seal ring (see clause 15 and 20.4). If valves complying with the requirements of this standard are to be used at service temperatures below – 30 °C, referen

Contents:

  • Foreword
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS 1868-1975+A1-1990 PDF

BS 1868-1975+A1-1990 PDF

$147.32 $294.64