Autoclaves for sterilization in laboratories-Safe use and operation. Code of practice
Publishing information: This part of BS 2646 is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 November 2023. It was prepared by Technical Committee CH/198, Sterilization and associated equipment and processes. A list of organizations represented on this committee can be obtained on request to the committee manager. Supersession This part of BS 2646 supersedes BS 2646‑3:1993 and BS 2646‑4:1991, which are withdrawn. Relationship with other publications BS 2646 is published in three parts. The other parts of the standard are as follows: Part 1: Design, construction, safety and performance – Specification; and Part 2: Planning and installation – Code of practice.
Information about this document: This is a full revision of the document, and this part of BS 2646 updates and combines BS 2646‑3:1993 and BS 2646‑4:1991, bringing together the safe use and operation requirements of BS 2646‑3:1993 with the maintenance requirements from BS 2646‑4:1991. This revision aligns BS 2646‑3 with the revised BS 2646‑1:2021. Pressure system requirements have been aligned with the Pressure Systems Safety Regulations 2000 [1]. References and clauses have been updated to reflect current Health and Safety Executive (HSE) guidance for laboratories and use of pressure systems, including the Waste from Electrical and Electronic Equipment (WEEE) directive [2]. It updates its references and clauses to reflect current HSE guidance for laboratories and use of pressure systems. The standard incorporates significant changes to the testing regime for both new and existing autoclaves and includes an additional section on removal and disposal. Most clauses have been significantly revised. This publication can be withdrawn, revised, partially superseded or superseded. Information regarding the status of this publication can be found in the Standards Catalogue on the BSI website at bsigroup.com/standards, or by contacting the Customer Services team. Where websites and webpages have been cited, they are provided for ease of reference and are correct at the time of publication. The location of a webpage or website, or its contents, cannot be guaranteed.
Presentational conventions: The provisions of this document are presented in roman (i.e. upright) type. Its recommendations are expressed in sentences in which the principal auxiliary verb is “should”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Where words have alternative spellings, the preferred spelling of the Shorter Oxford English Dictionary is used (e.g. “organization” rather than “organisation”). BRITISH STANDARD
Scope: This part of BS 2646 gives recommendations for the factors to be taken into account when devising procedures for the safe and effective use of laboratory autoclaves of the types specified in BS 2646‑1. NOTE 1 For example, autoclaves for the sterilization of goods and material which could be infected with organisms, the sterilization and/or processing of growth media or other materials required for the operation of a laboratory. NOTE 2 The procedures described are designed to: a) minimize risks to operators and other personnel; b) confirm the ability of the autoclave to effectively carry out each of the processes defined in BS 2646‑1; and c) plan and carry out maintenance tasks, including calibration, and to carry out performance qualification of the identified loads.