BS 2853-2011 PDF

BS 2853-2011 PDF

Specification for the testing of steel overhead runway beams for hoist blocks

$90.17 $180.34 -50%
Publisher
isbn 9780580719301
Product Code: BS 2853
Stock In Stock
Published: 10/31/2011
Number of Pages: 12
File Size: 1 file, 690 KB

Available Options

Product Description

Specification for the testing of steel overhead runway beams for hoist blocks

Publishing information: This British Standard is published by BSI and came into effect on 31 October 2011. It was prepared by Technical Committee CB/203, Design and execution of steel structures. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This British Standard, together with BS EN 1993-6 (and its associated National Annex), supersedes BS 2853:1957, which is withdrawn.

Information about this document: This is a full revision of the standard, and introduces the following principal changes. The detailed requirements for structural design have been removed. Requirements about the slopes of beams have been added. It has been clarified that the deflection limits for beams are relative to their supports. The former references to Statutory Requirements have been removed. The detailed requirements for Test Certificates have been removed. References to The Lifting Operations and Lifting Equipment Regulations 1998 [1] have been added. Previous editions of this British Standard also covered the structural design of the runway beams. This is now covered by BS EN 1993-6, in association with BS EN 1991-3, and their associated National Annexes.

Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.

Scope: This British Standard specifies requirements for the testing of fixed overhead runway beams made from rolled steel sections. This British Standard applies to the runway beams and their components only. It does not apply to supporting structures, travelling trolleys or lifting appliances operating on the beams, nor to runway beams for cranes that run on rails.

Contents:

  • Foreword
  • Scope
  • Bibliography

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS 2853-2011 PDF

BS 2853-2011 PDF

$90.17 $180.34