Aerospace Series. Specification for bolts, 100° countersunk head, D-slot recess in anodized aluminium alloy (unified threads)
Publishing information: This British Standard is published by BSI and came into effect on 30 November 1962. It was prepared by Technical Committee ACE/12, Aerospace fasteners and fastening systems. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This British Standard supersedes BS 2A 175:1962+A2:1985, which is withdrawn.
Information about this document: This revision of British Standard BS 2A 175 has been prepared to relate the standard to the relevant requirements of British Standard BS 4A 100. Additionally, provision has been made for closer limits on head protrusion, the values now shown being the same as those given in the American specification NAS 9800. This British Standard marks a departure from the traditional method of dimensioning countersunk head bolts by means of toleranced dimensions for head diameter, head thickness, land and angle. The method now adopted is known as the “flushness tolerance” method and was first used in a British Standard for countersunk fasteners in BS 1981. Its basic principles and advantages are outlined in Annex A to this standard, together with suggested methods of gauging. NOTE The values in British units are to be regarded as the standard. The start and finish of text introduced or altered by Amendment No.3 is indicated in the text by tags and . Minor editorial changes are not tagged. Previous amendments are not indicated.
Use of this document: It has been assumed in the preparation of this British Standard that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This British Standard specifies the materials, dimensions and inspection requirements for machined and anodized aluminium alloy bolts with 100° countersunk D-slot recess drive heads and Unified threads for aircraft.