Aerospace Series. Bolts, Pan Head, Slotted Drive, Unified Threads, Corrosion Resisting Steel, Strength Class 880 MPa, for Aircraft. Specification
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 May 2016. It was prepared by Technical Committee ACE/12, Aerospace fasteners and fastening systems. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession BS 3A 117:1962+A2:2016 supersedes BS 3A 117:1962 (Incorporating Amendment No 1:1962), which is withdrawn.
Information about this document: Amendment No.2:2016 introduces the following principle changes: the addition of high expansion heat resisting steel conforming to BS HR 650, to take account of the mechanical properties of these steels, the introduction of a part number code for bolts made from high expansion heat resisting steels (to be marked on the bolt surface), to distinguish them from bolts made from the BS S 80 material (see Clause 9). The start and finish of text introduced or altered by Amendment No.2:2016 is indicated in the text by tags . Minor editorial changes are not tagged. Previous amendments are not indicated.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This British Standard specifies the materials, dimensions and inspection requirements for corrosion resisting steel pan head bolts (Unified threads), Strength class 880 MPa, for aircraft.
Contents: