Specification for 2.5% nickel-chromium-molybdenum (high carbon) steel billets, bars, forging and parts (1 160 - 1 310 MPa: limiting ruling section 155 mm)
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 December 2014. It was prepared by Panel ACE/61/-/15, Steels for aerospace purposes, under the authority of Technical Committee ACE/61, Metallic materials for aerospace purposes. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This British Standard supersedes BS 2S 98:1964, which is withdrawn.
Information about this document: This is a full revision of the Standard, and introduces the following principal changes: the requirements are stated in tabular format in accordance with requirements are added for forgings in the softened condition (designation S 98G); limiting ruling section is increased from 150 mm to 155 mm; reference is made to the latest edition of BS S 100; and properties and dimensions are given in SI units. Hazard warnings WARNING. This British Standard calls for the use of substances and/or procedures that can be injurious to health if adequate precautions are not taken. It refers only to technical suitability and does not absolve the user from legal obligations relating to health and safety at any stage.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This British Standard specifies requirements for 2.5% nickel-chromium-molybdenum (high carbon) steel supplied in the following forms, and as parts. Forging stock: softened, designation S 98A. Forgings: hardened and tempered, designation S 98C. Forgings: softened, designation S 98G. Black bars for machining: hardened and tempered, designation S 98B. Black bars for machining: softened, designation S 98E. Bright bars for machining: hardened and tempered, designation S 98D. Bright bars for machining: softened, designation S 98F.
Contents:
- Foreword
- Scope
- Bibliography