BS 4250-2014 PDF

BS 4250-2014 PDF

Specification for commercial butane and commercial propane

$105.41 $210.82 -50%
Publisher
isbn 9780580831331
Product Code: BS 4250
Stock In Stock
Published: 11/30/2014
Number of Pages: 20
File Size: 1 file, 700 KB

Available Options

Product Description

Specification for commercial butane and commercial propane

Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 November 2014. It was prepared by Technical Committee PTI/15, Natural gas and gas analysis. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This British Standard supersedes BS 4250:1997, which is withdrawn.

Information about this document: The changes in this edition of BS 4250 are intended to align, wherever possible, the requirements of this standard with BS EN 589:2008+A1:2012 to reflect the situation that some UK refineries manufacture liquefied petroleum gas (LPG) to meet both standards. A number of test methods required by the previous edition of this standard have now been withdrawn, so these have been replaced by up-to-date test methods. Annex A has been updated to align with BS EN 589:2008+A1:2012, Annex C, including the alignment of gauge vapour pressure factors. Flammability limits have been updated in line with latest guidance. This British Standard calls for the use of substances and/or procedures that might be injurious to health if adequate precautions are not taken. It refers only to technical suitability and does not absolve the user from legal obligations relating to health and safety at any stage. Attention is drawn to the safety warnings given in the introduction to this standard.

Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.

Scope: This British Standard specifies requirements for commercial butane and commercial propane as supplied for general domestic and industrial fuel purposes. It applies to these products in cylinders and in bulk. NOTE 1 The requirements apply at the point of custody transfer. Withdrawal or loss of product from the vapour phase changes the composition of the product remaining in the liquid phase. Hence the product might then cease to meet specified requirements. It does not cover gases for testing gas appliances. NOTE 2 For gases to test gas appliances, see BS EN 437.

Contents:

  • Foreword
  • Introduction
  • Scope
  • Annexes
  • Annex A (normative) Method of calculation of gauge vapour pressure from
  • Annex B (normative) Method of test for odour of commercial butane or
  • Annex C (normative) Method for determination of hydrogen sulfide in
  • Annex D (informative) Explanatory notes on properties and test methods
  • Bibliography

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS 4250-2014 PDF

BS 4250-2014 PDF

$105.41 $210.82