Dimensions of probes and terminal units for medical gas supply systems. Requirements
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 June 2015. It was prepared by Subcommittee CH/121/6, Medical gas supply systems, under the authority of Technical Committee CH/121, Anaesthetic and respiratory equipment. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This British Standard supersedes BS 5682:1998, which is withdrawn.
Information about this document: This is a full revision of the standard, which takes account of product development and changes in products since the last edition. Its principal changes are: a) introduction of dimensions for probes and terminal outlets for helium/oxygen mixtures; b) specifications for the dimensions of the terminal outlets for all specified medical gases.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Requirements in this standard are drafted in accordance with Rules for the structure and drafting of UK standards, subclause J.1.1, which states, “Requirements should be expressed using wording such as: ‘When tested as described in Annex A, the product shall ...’”. This means that only those products that are capable of passing the specified test will be deemed to conform to this standard.
Scope: This British Standard specifies dimensions for probes and terminal units for the supply of medical gases (including vacuum). It is applicable to probes and terminal units for the following medical gases: oxygen; nitrous oxide; oxygen/nitrous oxide mixture; medical air 400 kPa; medical air 700 kPa and above; helium/oxygen mixture; and vacuum. This standard does not include specifications for probes and terminal units for: nitrogen for driving surgical tools; carbon dioxide; or oxygen 93.
Contents:
- Foreword
- Scope
- Bibliography