Planning, design, setting up and use of temporary suspended access equipment. Code of practice
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 October 2017. It was prepared by Subcommittee MHE/12/7, Suspended Access Equipment, under the authority of Technical Committee MHE/12, Lifting Platforms. A list of organizations represented on these committees can be obtained on request to their secretary. Supersession This British Standard supersedes BS 5974:2010, which is withdrawn.
Information about this document: This is a full revision of the standard, and introduces changes as a result of changes in the Construction (Design and Management) (CDM) Regulations [5] and the Work at Height Regulations [6]. This revision also introduces the following updates: a) the use of auxiliary hoists; and b) rescue requirements. Hazard warnings WARNING. This British Standard covers procedures that can be injurious to health if adequate precautions are not taken. It refers only to technical suitability of the temporary suspended access equipment (TSAE) and does not absolve the user from legal obligations relating to health and safety at any stage.
Use of this document: As a code of practice, this British Standard takes the form of guidance and recommendations. It should not be quoted as if it were a specification and particular care should be taken to ensure that claims of compliance are not misleading. Any user claiming compliance with this British Standard is expected to be able to justify any course of action that deviates from its recommendations.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its recommendations are expressed in sentences in which the principal auxiliary verb is “should”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Where words have alternative spellings, the preferred spelling of the Shorter Oxford English Dictionary is used (e.g. “organization” rather than “organisation”).
Scope: This British Standard gives recommendations for the selection, design, installation, inspection, thorough examination, use and maintenance of temporary installed suspended access equipment/ systems (TSAE), as defined in BS EN 1808. Non‑standard installations are covered by this British Standard. Steeplejacks and steeplejack operations are not covered by this British Standard. This British Standard is not applicable to permanently installed suspended access equipment which are covered by BS 6037‑1. Requirements for slung scaffolds, being TSPs on scaffold tubes or wire ropes, but which cannot be raised or lowered by the user, are given in BS EN 12811‑1. NOTE 1 BS EN 1808 specifies the design and construction requirements relating to the safety of suspended access equipment and is a harmonized standard supporting the provisions of the Machinery Directive [7]. BS EN 1808 is not retrospective and therefore does not relate to equipment manufactured before its introduction in 1999. NOTE 2 Systems made up of equipment/components designed, supplied and taken into service prior to the existence of harmonized standards are recommended to be in accordance with the British Standards in force at the time of the equipment’s manufacture and this British Standard.