Installation and maintenance of gas fired catering appliances for use in all types of catering establishments (2nd and 3rd family gases). Specification
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 March 2020. It was prepared by Technical Committee GSE/30, Gas Installations (1st, 2nd, 3rd family gases). A list of organizations represented by this committee can be obtained on request to its secretary. Supersession This British Standard supersedes BS 6173:2009, which is withdrawn.
Information about this document: This is a full revision of the standard to reflect changes in installation practice and legislation. This publication can be withdrawn, revised, partially superseded or superseded. Information regarding the status of this publication can be found in the Standards Catalogue on the BSI website at bsigroup.com/standards, or by contacting the Customer Services team. Where websites and webpages have been cited, they are provided for ease of reference and are correct at the time of publication. The location of a webpage or website, or its contents, cannot be guaranteed.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type and does not constitute a normative element. Where words have alternative spellings, the preferred spelling of the Shorter Oxford English Dictionary is used (e.g. “organization” rather than “organisation”). Requirements in this standard are drafted in accordance with Rules for the structure and drafting of UK standards, subclause G.1.1, which states, “Requirements should be expressed using wording such as: ‘When tested as described in Annex A, the product shall ...’”. This means that only those products that are capable of passing the specified test will be deemed to conform to this standard.
Scope: This British Standard specifies requirements for the installation, servicing and maintenance of new and previously-used gas-fired catering appliances used in catering establishments, burning 2nd or 3rd family gases. This British Standard covers appliances, such as cookers, fish and chip frying ranges, fryers, ovens, café boilers and urns, bain-marie units, tandoori ovens, kebab grills and barbecues. This British Standard also applies to the installation of typical domestic cookers or leisure appliances such as barbecues when installed in commercial catering sites or establishments. It is not applicable to LPG catering installations where appliances are sited temporarily in the open air, marquees or tents, or to LPG installations in mobile catering vehicles (see UKLPG CoP 24, Part 3 [N1]). NOTE 1 This British Standard is not intended to apply to primarily domestic premises, e.g. those supplying a small number of clients on a bed and breakfast basis.