Guide to low temperature properties and cold weather use of diesel fuels and gas oils
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 July 2012. It was prepared by Technical Committee PTI/2, Liquid fuels. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession BS 6380:2012+A1:2016 superseded BS 6380:2012, which has been withdrawn. BS 6380:2012+A2:2020 supersedes BS 6380:2012+A1:2016, which is withdrawn.
Information about this document: This British Standard has been prepared as a guide because it does not set out to cover the subject completely, but is intended to help individual users of the fuels covered, who will probably require other expert guidance in applying some of the recommendations. Some further guidance material is listed in the bibliography. This British Standard has been prepared in support of the automotive diesel specification BS EN 590 and the fuel oil specification BS 2869, but also refers to British Standards that cover in detail the storage of fuel oils. Text introduced or altered by Amendments No. 1 and No. 2 respectively is indicated in the text by tags and . Minor editorial changes are not tagged. BS 6380:2012 was a full revision of the standard, and introduced the following principal changes: changes in seasonality dates. Seasonality dates are now specified in the relevant British Standards, BS 2869 for fuel oil for agricultural, domestic and industrial engines and burners, and a change to the cold filter plugging point test method reference to align with that currently specified in BS EN 590; to reflect that, as a measure to reduce greenhouse gas emissions (see The Renewable Transport Fuel Obligations Order [1]), Fatty Acid Methyl Ester (FAME) is now permitted as a component as specified with a consequent possible effect on additive addition, low‑temperature solids deposition and an increased propensity for microbiological proliferation. Copyright is claimed on Table A.1. The Copyright holder is UK Petroleum Industry Association, 37 – 39 High Holborn, London, WCIV 6AA, UK. Hazard warnings WARNING. This British Standard calls for the use of substances and/or procedures that can be injurious to health if adequate precautions are not taken. It refers only to technical suitability and does not absolve the user from legal obligations relating to health and safety at any stage.
Use of this document: As a guide, this British Standard takes the form of guidance and recommendations. It should not be quoted as if it were a specification or a code of practice and claims of compliance cannot be made to it. ii © THE BRITISH STANDARDS INSTITUTION 2020 – ALL RIGHTS RESERVED It has been assumed in the preparation of this British Standard that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced.
Presentational conventions: The guidance in this standard is presented in roman (i.e. upright) type. Any recommendations are expressed in sentences in which the principal auxiliary verb is “should”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Where words have alternative spellings, the preferred spelling of the Shorter Oxford English Dictionary is used (e.g. “organization” rather than “organisation”).
Scope: This British Standard gives guidance on the low temperature properties and cold weather use of diesel fuel conforming to BS EN 590 and gas oils conforming to class A2 and class D of This British Standard does not address the use of 100% FAME as an automotive fuel or a heating fuel, such as that specified in BS EN 14214. Clause 3 and Clause 4 give details of the fuel classes and their low temperature properties. Clause 5 to Clause 8 give recommendations for fuel quality and treatment, the cold weather use of bulk handling and storage systems, cold weather operation of diesel‑engined vehicles and mobile automotive plant and remedial measures for fuel starvation in oil‑fired burner systems.