Suitability of non-metallic materials and products for use in contact with water intended for human consumption with regard to their effect on the quality of the water-Methods of test-Samples for testing
Publishing information: This part of BS 6920 is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 June 2014. It was prepared by Technical Committee EH/6, Effects of materials on water quality. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This part of BS 6920 supersedes BS 6920-2.1:2000+A3:2008, which is withdrawn. Relationship with other publications The following parts and sections of BS 6920 have been published. Part 1: Specification; Part 2: Methods of test; Section 2.1: Samples for testing; Section 2.2: Odour and flavour of water; Subsection 2.2.1: General method of test; Subsection 2.2.2: Method of testing odours and flavours imparted to water by multi-layered hoses and composite pipes and tubes; Subsection 2.2.3: Method of testing odours and flavours imparted to water by hoses for conveying water for food and drink preparation; Section 2.3: Appearance of water; Section 2.4: Growth of aquatic microorganisms test; Section 2.5: The extraction of substances that may be of concern to public health; Section 2.6: The extraction of metals; Part 3: High temperature tests; Part 4: Method for the GCMS identification of water leachable organic substances.
Information about this document: This is a full revision of the standard, and introduces the following principal changes: New definitions for the terms multi-layered product (see 3.2), inradius (3.5), thermoplastic material (3.6), thermosetting material (3.7), cure (3.8), solvent cement (3.10) and porous seal coat (3.11) have been provided. The specification of metal couplings has been changed (see 4.2.2). A new requirement for porous seal coats has been added (see 6.13.2). New requirements for in-situ applied pipe linings and coatings (see 7.2), resin anchors (7.7) and solvent cements (7.8) have been added. Reporting requirements have been amended (see Clause 9). Hazard warnings WARNING. This British Standard calls for the use of substances and/or procedures that can be injurious to health if adequate precautions are not taken. It refers only to technical suitability and does not absolve the user from legal obligations relating to health and safety at any stage.
Use of this document: It has been assumed in the preparation of this part of BS 6920 that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its methods are expressed as a set of instructions, a description, or in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This section of BS 6920 describes the preparation of test samples of all types of non-metallic (including cementitious) materials and products, including water fittings and components, pipes and materials used in coating, protection, lining, jointing, sealing and lubrication, for their suitability for use in contact with water intended for human consumption, with regard to their effect on the quality of the water. This standard does not cover metallic materials and products, unless they will be used in conjunction with a non-metallic material, e.g. coating. NOTE Under the relevant National Regulations [1] to [7] , the National Regulator may specify additional provisions in some cases and will assess the significance of the results obtained.
Contents:
- Foreword
- Scope
- Bibliography