BS 7000-2-2015 PDF

BS 7000-2-2015 PDF

Design management systems-Guide to managing the design of manufactured products

$194.31 $388.62 -50%
Publisher
isbn 9780580856808
Product Code: BS 7000-2
Stock In Stock
Published: 09/30/2015
Number of Pages: 46
File Size: 1 file, 970 KB

Available Options

Product Description

Design management systems-Guide to managing the design of manufactured products

Publishing information: This part of BS 7000 is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 September 2015. It was prepared by Subcommittee TDW/4/7, Technical product realization – BS 8887 design for MADE, under the authority of Technical Committee TDW/4, Technical product realization. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This part of BS 7000 supersedes BS 7000-2:2008, which is withdrawn. Relationship with other publications BS 7000 Design management systems, consists of the following parts: Part 1: Guide to managing innovation; Part 2: Guide to managing the design of manufactured products; Part 3: Guide to managing service design; Part 4: Guide to managing design in construction; Part 6: Managing inclusive design – Guide; Part 10: Vocabulary of terms used in design management. Other parts may be added.

Information about this document: This part of BS 7000 is a full revision of the standard and introduces multi-lifecycle considerations, along with the recommendations given in

Use of this document: As a guide, this part of BS 7000 takes the form of guidance and recommendations. It should not be quoted as if it were a specification or a code of practice and claims of compliance cannot be made to it.

Presentational conventions: The guidance in this standard is presented in roman (i.e. upright) type. Any recommendations are expressed in sentences in which the principal auxiliary verb is “should”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.

Scope: This part of BS 7000 gives guidance on managing the design of all types of manufactured products. It deals with every stage of the design process from product concept through to delivery, use and end-of-life processing. NOTE 1 This standard recognizes that small enterprises or those specializing in one-off products or special purpose end-of-life equipment often need to adapt the process to suit their method of operation. It is intended for use by all relevant levels of management, from board level to individual project level, in all types of organizations involved in the design of manufactured products. Guidance is given on the application of general principles and techniques to the management of design, raising awareness of management issues and emphasizing the need for an integrated approach to the design of products. This standard is not intended to define design techniques. NOTE 2 For many products, particularly those that are complex, an integrated multi-disciplinary approach to design is needed. Documents recommended for guidance on general management techniques are listed in the Bibliography. Guidance on the management of innovation, service design and construction design is given in BS 7000-1, BS 7000-3 and BS 7000-4 respectively. NOTE 3 Guidance on procedures needed to meet statutory requirements, such as health and safety, or product certification and liability, is not intended to be comprehensive. Reference needs to be made to other documents where appropriate. NOTE 4 This standard is intended to complement BS EN ISO 9001.

Contents:

  • Foreword
  • Introduction
  • Scope
  • Bibliography

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS 7000-2-2015 PDF

BS 7000-2-2015 PDF

$194.31 $388.62