Code of practice for the safe use of cranes-Inspection, maintenance and thorough examination. General
Publishing information: This sub-part of BS 7121-2 is published by BSI Standards Limited, under license from the British Standards Institution and came into effect on 30 November 2012. It was prepared by Subcommittee MHE/3/11, Crane safety and testing, under the authority of Technical Committee MHE/3, Cranes and derricks. A list of organizations represented on these committees can be obtained on request to their secretary. Supersession Together with BS 7121-2-3, BS 7121-2-4, BS 7121-2-5 and BS 7121-2-7, this sub-part of BS 7121-2 supersedes BS 7121-2:2003, which will be withdrawn when all these sub-parts have been published. Relationship with other publications The BS 7121 series is being revised. The following new sub-parts of BS 7121-2 have been published or are in preparation: Part 2-1: Inspection, maintenance and thorough examination – General; Part 2-3: Inspection, maintenance and thorough examination – Mobile cranes; Part 2-4: Inspection, maintenance and thorough examination – Loader cranes; Part 2-5: Inspection, maintenance and thorough examination – Tower cranes; Part 2-7: Inspection, maintenance and thorough examination – Overhead travelling cranes including portal and semi-portal cranes, hoists, and their supporting structures; Part 2-9: Inspection, maintenance and thorough examination – Cargo handling and container cranes. When all sub-parts of BS 7121-2 have been published, it is intended that CP 3010 will be withdrawn and BS 5744 will be revised to cover manually operated and light cranes only. This sub-part of BS 7121-2 is intended to be read in conjunction with the appropriate sub-part(s) of BS 7121-2 dealing with the relevant crane type(s).
Information about this document: The Health and Safety Executive (HSE) commends the use of this British Standard to those who have duties under the Health and Safety at Work etc. Act 1974 [1]. This standard was drawn up with the participation of HSE representatives and it will be referred to in the relevant HSE publications. The BS 7121 series has been accepted by the HSE as representing the consensus of opinion based on practical experience for safety of cranes. Hazard warnings WARNING. This British Standard calls for the use of procedures that can be injurious to health if adequate precautions are not taken. It refers only to technical suitability and does not absolve the user from legal obligations relating to health and safety at any stage.
Use of this document: As a code of practice, this sub-part of BS 7121-2 takes the form of guidance and recommendations. It should not be quoted as if it were a specification and particular care should be taken to ensure that claims of compliance are not misleading. Any user claiming compliance with this sub-part of BS 7121-2 is expected to be able to justify any course of action that deviates from its recommendations. It has been assumed in the preparation of this British Standard that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its recommendations are expressed in sentences in which the principal auxiliary verb is “should”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This sub-part of BS 7121-2 gives general recommendations for the pre-use checks, in-service inspection, maintenance, thorough examination (following installation, in service and following exceptional circumstances) and supplementary testing of cranes and associated equipment, including gantries, runways and other supporting structures. This sub-part of BS 7121-2 is also applicable to hoists, derricks, telehandlers, fork lift trucks and excavators when used to lift suspended loads. For the purposes of this standard all these are included under the term “cranes”. It is not applicable to construction hoists, mast climbing work platforms, mobile elevating work platforms, jacks and suspended access equipment.
Contents:
- Foreword
- Scope
- Annexes
- Annex A (informative) Beaufort scale
- Annex B (informative) Sea state code
- Annex C (informative) Example of personnel carrier pre-use check form
- Bibliography