Components for smoke control systems-Code of practice for planning, design, installation, commissioning and maintenance
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 December 2013. It was prepared by Technical Committee FSH/25, Smoke, heat control systems and components. A list of organizations represented on this committee can be obtained on request to its secretary.
Information about this document: Annex D contains a number of figures reproduced by permission of the Federation of Environmental Trade Associations. Copyright is claimed on these figures. Copyright holders are the Federation of Environmental Trade Associations, 2 Waltham Court, Milley Lane, Hare Hatch, Reading, Berkshire, RG10 9TH.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its recommendations are expressed in sentences in which the principal auxiliary verb is “should”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. The word “should” is used to express recommendations of this standard. The word “may” is used in the text to express permissibility, e.g. as an alternative to the primary recommendation of the clause. The word “can” is used to express possibility, e.g. a consequence of an action or an event. Notes and commentaries are provided throughout the text of this standard. Notes give references and additional information that are important but do not form part of the recommendations. Commentaries give background information.
Use of this document: As a code of practice, this British Standard takes the form of guidance and recommendations. It should not be quoted as if it were a specification and particular care should be taken to ensure that claims of compliance are not misleading. Any user claiming compliance with this British Standard is expected to be able to justify any course of action that deviates from its recommendations. Departures from the recommendations of this British Standard are possible through consultation and discussion, and with the agreement of all interested parties (see 5.2). It has been assumed in the preparation of this British Standard that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced.
Scope: This British Standard gives recommendations for the planning, design, installation, commissioning and maintenance of smoke control systems, including smoke clearance, in and around buildings. The recommendations are applicable to systems intended for the protection of life and/or protection of property, including: a) natural smoke ventilation; b) mechanical smoke ventilation; c) smoke barriers; d) smoke and heat exhaust ducts; e) smoke dampers, and their controls, power supplies and interconnections. This British Standard is not applicable to non-fire-related functions of smoke control systems. This British Standard does not give recommendations as to whether or not to install smoke control systems in any given premises.
Contents:
- Foreword
- Introduction
- Scope
- Annexes
- Annex A (informative) Statutory responsibility for a smoke control system
- Annex B (informative) Model certificates
- Annex C (informative) Model format of system logbook
- Annex D (informative) Location of roof ventilators in areas potentially subject to
- Bibliography