BS 746-2014 PDF

BS 746-2014 PDF

Specification for gas meter unions and adaptors

$105.41 $210.82 -50%
Publisher
isbn 9780580748929
Product Code: BS 746
Stock In Stock
Published: 11/30/2014
Number of Pages: 22
File Size: 1 file, 720 KB

Available Options

Product Description

Specification for gas meter unions and adaptors

Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 November 2014. It was prepared by Technical Committee GSE/25, Gas meters. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession BS 746:2014 supersedes BS 746:2005+A1:2009, which is withdrawn. Relationship with other publications This standard specifies fittings to be used in conjunction with gas meters such as those specified by BS EN 1359 and BS EN 14236.

Information about this document: This is a full revision of the standard, and introduces the following principal changes. Dimensional changes have been made to ensure that the flat parts of the nuts engage directly on the flat parts of the liners such that even pressure is applied to the surfaces of the washers. The properties of the sealing washer have been redefined. Additional tests for fittings and washer performance have been added. Hexagonal nuts are now permitted as an alternative to octagonal nuts. This document may be used in the procurement of fittings.

Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.

Scope: This British Standard specifies requirements and test methods for unions and adaptors for the installation of low pressure gas meters. It is applicable to unions and adaptors for gas meters for use with 1st, 2nd and 3rd family gases at temperatures between –20 °C and +60 °C, up to a maximum operating pressure of 75 mbar 1) and a maximum incidental pressure of 200 mbar. The gas tightness of the gas meter unions and adaptors is also specified. NOTE The tests specified in this standard are type tests, except for that specified in 4.2.3.

Contents:

  • Foreword
  • Scope
  • Bibliography

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS 746-2014 PDF

BS 746-2014 PDF

$105.41 $210.82