Personal fall protection equipment. Anchor systems. System design, installation and inspection. Code of practice
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 November 2019. It was prepared by Technical Committee PH/5, Personal Fall Protection. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession BS 7883:2019 supersedes BS 7883:2005, which is withdrawn. Relationship with other publications This British Standard is intended to complement BS 8610, BS EN 795, PD CEN/TS 16415 by recommending good practice as followed by competent practitioners for installing and maintaining products conforming to those standards.
Information about this document: This British Standard provides information relating to anchor systems and recommendations for installation and use in conjunction with personal fall protection equipment for protection against falls from a height. This revision of BS 7883 gives recommendations additional to those in the previous edition for system design, installation and inspection of anchor systems, including: a) the role of the system designer is introduced; b) applications and product types have been introduced, based on BS 8610; c) recommendations have been introduced for: 1) documentation, including the system technical file; 2) configurations in use, in particular rope access; 3) positioning; 4) proof test loads; and 5) the inspection of previously installed anchor systems.
Use of this document: As a code of practice, this British Standard takes the form of guidance and recommendations. It should not be quoted as if it were a specification and particular care should be taken to ensure that claims of compliance are not misleading. Any user claiming compliance with this British Standard is expected to be able to justify any course of action that deviates from its recommendations. It has been assumed in the preparation of this British Standard that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced. BRITISH STANDARD
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its recommendations are expressed in sentences in which the principal auxiliary verb is “should”. This British Standard includes examples which are illustrative and not a definitive list. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This British Standard gives recommendations for the system design, installation, use, maintenance and inspection of anchor systems incorporating anchor devices conforming to BS EN 795, PD CEN/ TS 16415 and/or anchor systems conforming to BS 8610. This British Standard also gives recommendations for the inspection of anchor systems installed prior to this edition of the British Standard. NOTE 1 Anchor systems installed prior to this edition of the British Standard, but which have been inspected in accordance with Section 4, can only be certified as meeting the inspection recommendations of Section 4. The inspector can only claim that the anchor system conforms to the British Standard to which it was originally installed, e.g. “the anchor system was installed in accordance with BS 7883:2005 and the inspection has been carried out in accordance with BS 7883:2019, Section 4”. This British Standard is only applicable to anchor systems for the direct attachment of PFPE for use in the workplace. This British Standard is not applicable to: a) the lifting of equipment; b) anchor points comprising holes formed in the base material for the direct attachment of personal fall protection equipment (PFPE), e.g. hole drilled through steel girder; c) anchor points formed by the welded attachment of bars or plates to steel structures for the direct attachment of the PFPE, e.g. loops of steel bar or flat plates incorporating a hole, welded to a steel structure, unless: 1) such anchor points form part of a manufactured product which has been successfully tested in accordance with BS 8610; or 2) the manufacturer, installer or inspector of such anchor points can demonstrate that the anchor point conforms to all relevant requirements of BS 8610, BS EN 795 or PD CEN/ TS 16415, in which case the documentation certifying conformity to BS 8610, BS EN 795 or PD CEN/TS 16415 becomes part of the documentation provided to the duty holder; d) anchor systems for attachment of collective protection