Protective clothing and equipment for use in violent situations and in training-Gloves. Requirements and test methods
Publishing information: This part of BS 7971 is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 August 2016. It was prepared by Subcommittee PH/3/12, Protective clothing and equipment for use in violent situations and training under the authority of Technical Committee PH/3, Protective clothing. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This part of BS 7971 supersedes BS 7971-6:2003, which is withdrawn.
Information about this document: This part of BS 7971 has been substantially revised in association with the Home Office. The aims of the revision were to amalgamate appropriate content from BS 7971-1, BS 7971-2, BS 7971-7 and BS 7971-6 and to reference the Home Office publication, Slash resistance standard for UK police (2006) [N1]. This British Standard contains public sector information licensed under the Open Government Licence v2.0. This full revision of the standard introduces the following principal changes by addition of clauses covering: innocuousness; sizing; marking; user information; cleaning; modified resistance to chemicals; and a high cut resistance test.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This part of BS 7971 specifies requirements and test methods for two types of gloves, general duty gloves and public order gloves intended to be used for specialist operational activities such as public order situations and public order training. They are intended to provide protection against different hazards such as mechanical risk, heat and flame and small volumes of certain liquids. NOTE If the risk assessment of other specialist gloves identifies hazards covered by this standard then in addition to any specific test requirements they might have, elements from this standard can be referenced.
Contents:
- Foreword
- Introduction
- Scope
- Annexes
- Annex A (informative) Rationale for simplification of ergonomic evaluation
- Annex B (informative) Handcuff key
- Annex C (informative) Resistance to penetration by a hypodermic needle
- Bibliography