Design, installation and configuration of intruder and hold-up alarm systems designed to generate confirmed alarm conditions. Code of practice
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 June 2021. It was prepared by Subcommittee GW/1/2, Installed alarm systems, under the authority of Technical Committee GW/1, Electronic security systems and products. A list of organizations represented on these committees can be obtained on request to the committee manager. Supersession This British Standard supersedes BS 8243:2010+A1:2014, which will be withdrawn on 30 June 2022. Relationship with other publications This British Standard is intended to be read in conjunction with BS EN 50131 (all parts) as implemented by PD 6662.
Information about this document: This is a full revision of the standard and introduces the following principal changes: the previous provision for all intruder and hold-up alarm systems (I&HAS) to include sequential confirmation is now optional; removal of a number of prescriptive methods from Clause 5 that set recommendations for the design of audio or visual confirmation; removal of the provision to declare to the response authority when using detectors incorporating two movement detectors of the same technology within a single housing; confirmation of hold-up alarm (HUA) by telephone call back by an alarm receiving centre (ARC) is now permitted only for residential premises; confirmation procedures have changed to accommodate the different processes relating to sequential confirmation or where the confirmation status is decided at an ARC; removal of Clause 7, which is to be included in an ARC standard, BS 9518; and addition of an option to set/unset the intruder alarm system (IAS) using a remote device. This publication can be withdrawn, revised, partially superseded or superseded. Information regarding the status of this publication can be found in the Standards Catalogue on the BSI website at bsigroup.com/standards, or by contacting the Customer Services team. Where websites and webpages have been cited, they are provided for ease of reference and are correct at the time of publication. The location of a webpage or website, or its contents, cannot be guaranteed.
Use of this document: As a code of practice, this British Standard takes the form of recommendations and guidance. It is not to be quoted as if it were a specification. Users are expected to ensure that claims of compliance are not misleading. Users may substitute any of the recommendations in this British Standard with practices of equivalent or better outcome. Any user claiming compliance with this British Standard is expected to be able to justify any course of action that deviates from its recommendations. ii © THE BRITISH STANDARDS INSTITUTION 2021 – ALL RIGHTS RESERVED
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its recommendations are expressed in sentences in which the principal auxiliary verb is “should”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. The word “should” is used to express recommendations of this standard. The word “may” is used in the text to express permissibility, e.g. as an alternative to the primary recommendation of the clause. The word “can” is used to express possibility, e.g. a consequence of an action or an event. Notes and commentaries are provided throughout the text of this standard. Notes give references and additional information that are important but do not form part of the recommendations. Commentaries give background information. Where words have alternative spellings, the preferred spelling of the Shorter Oxford English Dictionary is used (e.g. “organization” rather than “organisation”).
Scope: This British Standard gives recommendations for the design, installation and configuration of intruder and hold‑up alarm systems (I&HAS) that incorporate alarm confirmation technology, where such I&HAS have signalling systems that signal to an alarm receiving centre (ARC) and require a police response. It includes recommendations intended to minimize the likelihood of false alarms. NOTE 1 Hold-up alarm system (HAS) alarm confirmation can be used as required in the NPCC and ACPOS/PS security systems policies [1] [2]. NOTE 2 Confirmation of a hold-up alarm (HUA) might be required to regain police response only where the URN (unique reference number) has been withdrawn following false alarms. See the NPCC and ACPOS/PS policies [1] [2].