Furniture. Chairs with electrically operated support surfaces. Requirements
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 July 2013. It was prepared by Subcommittee FW/0/2, Domestic and contract furniture, under the authority of Technical Committee FW/0, Furniture. A list of organizations represented on these committees can be obtained on request to their secretary. Supersession This British Standard supersedes BS 8474:2006, which is withdrawn.
Information about this document: This is a full revision of the standard and incorporates the following principle changes. a) The standard now specifies performance requirements for chairs suitable for users weighing up to 110 kg and up to 160 kg. b) Requirements regarding shear and squeeze points are not specified. Instead, a motion lockout control is specified that can be operated by the user or a responsible person to prevent unintended movement of the chair. The requirements of this standard are based on tests intended to reproduce normal use and common types of misuse to which chairs with electrically operated support surfaces could be subjected. However, the tests do not reproduce any abuse to which the chair might be subjected. Manufacturers and importers of chairs with electrically operated support surfaces should be aware that if any part of the marketing of their products can be interpreted as claiming that a product is: “intended by the manufacturer to be used for human beings for the purpose of: treatment or alleviation of disease; treatment, alleviation of or compensation for an injury or handicap;” such chairs might be considered to be medical devices and therefore subject to the provisions of EC Directive 93/42/EEC (the Medical Devices Directive) [1]. All aspects of marketing may be considered when deciding if a product is a medical device, including point of sale claims. Manufacturers who do not have control over claims made at the point of sale are advised to consider whether they should take legal advice regarding their position. Hazard warnings WARNING. This British Standard calls for the use of procedures that can be injurious to health if adequate precautions are not taken. It refers only to technical suitability and does not absolve the user from legal obligations relating to health and safety at any stage.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This British Standard specifies requirements and test methods for chairs with support surfaces the position of which can be adjusted electrically by the seated person and/or a responsible person, including riser chairs, recliner chairs and rise and recline chairs. It specifies chairs suitable for adult users weighing up to 110 kg and up to 160 kg, with a normal body mass distribution. The standard is applicable to single and multiple seating units. In the text of this standard the term “chairs” is used to refer to chairs with electrically operated support surfaces. The term “chairs” also refers to multiple seating units. The standard is applicable to chairs intended for domestic and non-domestic use. This standard specifies only the safety, strength, stability and durability of the chair structure. It does not specify the fire resistance or durability properties of filling materials, upholstery fabrics or foam cushions. Also, it does not specify the electrical safety of the support surface adjustment mechanism. The requirements in this standard are applicable to chairs in the fully assembled condition, ready for use. The standard does not specify resistance to degradation of the structural materials by sunlight or chemical attack. This standard does not cover any ancillary devices attached to, or built into, the chair structure, such as a table, refrigerator or television remote control (see Note 2). NOTE 1 Chairs which are medical devices are required to conform to EC Directive 93/42/EEC (the Medical Devices Directive) [1]. NOTE 2 If conformity to a standard is to be claimed for such ancillary devices, conformity assessment against the relevant standard(s) would need to be carried out separately.
Contents:
- Scope
- Annexes
- Annex A (normative) Method of test for the durability of the support surface
- Annex B (normative) Method of test for stability of riser chairs in the raised
- Annex C (normative) Test for the durability of markings
- Bibliography