Specification for domestic gas meter boxes and meter bracket
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 December 2017. It was prepared by Technical Committee GSE/25, Gas meters. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession BS 8499:2017 supersedes BS 8499:2009, which is withdrawn.
Information about this document: This new edition of BS 8499 incorporates technical changes to Clause 6 and Figure 6 only. It does not represent a full review or revision of the standard, which will be undertaken in due course.
Use of this document: It has been assumed in the preparation of this British Standard that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Where words have alternative spellings, the preferred spelling of the Shorter Oxford English Dictionary is used (e.g. “organization” rather than “organisation”).
Scope: This British Standard specifies requirements for gas meter boxes for use with single gas meter installations conforming to BS 6400, which: a) are supplied with gases of the 2nd and 3rd family, with a maximum capacity of 6 m3/h and a maximum operating pressure not exceeding 2 bar; and b) incorporate any of the following meters: diaphragm, ultrasonic, credit or prepayment. It does not apply to multiple meter installations which are installed in the same housing. NOTE 1 The composition of fuel gases of the 2nd and 3rd family is specified in BS EN 437. NOTE 2 All pressures quoted in this standard are gauge pressures. It covers the following designs of meter box, including any associated box extensions: 1) built-in; 2) surface mounted; 3) semi-concealed; 4) universal. It does not cover security shrouds intended to provide additional protection to meter installations. This British Standard also specifies requirements for the design of the standard meter bracket.