Flood resistance products-Building products. Specification
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 September 2019. It was prepared by Technical Committee CB/501, Flood risk and watercourses. A list of organizations represented on this committee can be obtained on request to the committee manager. Supersession BS 851188-1:2019 superseded PAS 1188‑1:2014 and PAS 1188‑3:2014, which have been withdrawn. BS 851188-1:2019+A1:2021 supersedes BS 851188-1:2019, which is withdrawn. Relationship with other publications BS 851188, Flood resistance products, is issued in two parts: Part 1: Building products – Specification; and Part 2: Perimeter barrier systems – Specification. Attention is drawn to the need to consider the prevention of the ingress of flood water into buildings through building fabric (i.e. walls and floors), horizontal pipes, waste water fittings and floor gullies. Anti-flood devices for buildings are covered in BS EN 13564‑1. BS 851188‑1 can be used in conjunction with CIRIA Code of practice and guidance for property flood resilience [1]. This document sets out a complete methodology for the delivery of flood resilience and provides guidance for flood hazard and building assessment, design, installation and aftercare of flood resilience products and associated measures.
Information about this document: Text introduced or altered by Amendment No. 1 is indicated in the text by tags . Minor editorial changes are not tagged. Test laboratory accreditation. Users of this British Standard are advised to consider the desirability of selecting test laboratories that are accredited to BS EN ISO/IEC 17025 by a national or international accreditation body. This publication can be withdrawn, revised, partially superseded or superseded. Information regarding the status of this publication can be found in the Standards Catalogue on the BSI website at bsigroup.com/standards, or by contacting the Customer Services team. Where websites and webpages have been cited, they are provided for ease of reference and are correct at the time of publication. The location of a webpage or website, or its contents, cannot be guaranteed.
Use of this document: It has been assumed in the preparation of this British Standard that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced. ii © THE BRITISH STANDARDS INSTITUTION 2021 – ALL RIGHTS RESERVED
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Where words have alternative spellings, the preferred spelling of The Shorter Oxford English Dictionary is used (e.g. “organization” rather than “organisation”).
Scope: This British Standard specifies requirements for the designation, testing, factory production control, installation manual, deployment instructions, user manual and marking for different types and configurations of flood resistance products. This British Standard is applicable to flood resistance products intended for use in the temporary sealing of building apertures and entrances to properties, including boards, skirt and wall sealant systems, and flood doors, in the event of static flood water rising above a minimum level of 540 mm above aperture threshold level, except where they are designed to completely cover or replace small apertures, such as airbricks or air vents. The flood resistance products are expected to be effective at flood heights from ground level to the designated maximum water depth (DMWD). It covers BRITISH STANDARD