Guide to the design, installation, testing and maintenance of services supplying water for domestic use within buildings and their curtilages. Complementary guidance to BS EN 806
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 September 2015. It was prepared by Sub-committee B/504/2, Internal systems and components, under the direction of Technical Committee B/504, Water Supply. A list of organizations represented on these committees can be obtained on request to their secretary. Supersession This British Standard supersedes BS 8558:2011, which is withdrawn.
Information about this document: The content of this British Standard was originally taken from BS 6700:2006+A1:2009, which was withdrawn on publication of BS EN 806 (all parts). This is a full revision of the standard to keep it up to date. Figure 12f) is reproduced by permission of the Water Regulations Advisory Scheme (WRAS). Copyright is claimed on these figures. Copyright holders are WRAS, Willow Road, Pen y Fan Industrial Estate, Crumlin, Gwent NP11 4EG. Figure 15 is reproduced by permission of the Chartered Institute of Plumbing and Heating Engineering (CIPHE). Copyright is claimed on these figures. Copyright holders are CIPHE, 64 Station Lane, Hornchurch, Essex RM12 6NB, United Kingdom.
Presentational conventions: The guidance in this standard is presented in roman (i.e. upright) type. Any recommendations are expressed in sentences in which the principal auxiliary verb is “should”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This British Standard provides complementary guidance to BS EN 806. It is a guide to the design, installation, alteration, testing, operation and maintenance of services supplying water for domestic use within buildings and their curtilages. BS EN 806 does not cover underground pipework, but this British Standard gives guidance on underground pipework within the curtilage of a building. This British Standard does not cover: a) the detailed methods of chemical treatment and maintenance of water distribution systems; b) workmanship; or c) space heating systems. NOTE Annex A gives examples of pumped systems. Annex B provides guidance on the calculation of hot water storage systems, while Annex C provides calculations for pipe sizing.
Contents:
- Foreword
- 0 Introduction
- Scope
- Annexes
- Annex A (informative) Examples of pumped systems
- Annex B (informative) Guidance on the calculation of hot water storage
- Annex C (informative) Pipe sizing calculations